The First Start; Start - Reely 1530490 Blackster R7 2.0 FPV WiFi RtF Notice D'emploi

12. The First Start

a) Start
The operation and handling of remote controlled flight models must be learned! If you have never steered
such a model, start especially carefully and get used to the reactions of the model to the remote control
commands first. Do be patient! Use the information from chapter 11 as reference.
Do not take any risks when operating the product! Your own safety and that of your environment depends
completely on your responsible use of the model.
Connect the flight battery. For this, you need to open the battery
compartment (figure 5, item 3) by pushing the lid backwards by the
groove and folding it open.
Now push the rechargeable battery into the intended compartment.
The cables point out of the quadrocopter at the back. Now connect
the two-pin plug of the rechargeable battery to the socket of the
quadrocopter in the correct polarity (also see figure 11; observe
contours of the plug).
The LEDs in the model start to flash quickly. Close the battery
compartment again.
Observe that no cables are crushed here.
• Place the model on a level surface as smooth as possible (e.g. stone floor). A carpet is less suitable because the
landing legs may bet caught in the carpet easily. The front (red) rotors point forward (away from you).
• Turn on the remote control transmitter by pushing the on/off switch
(see figure 3, item 1). The transmitter confirms this with a double
sound. The control LED (fig. 3, item 2) will flash.
• Push the left control lever (figure 3, item 3) forward until a control
sound sounds.
• Pull the left control lever (figure 3, item 3) backwards until a control
sound sounds. The control LED at the transmitter and the LEDs at
the quadrocopter are now permanently lit.
The quadrocopter is now bound to the transmitter and ready to start.
• Start the rotors by putting both control levers to the intended position as shown in figure 12. If you now put both
control levers back into the neutral position, the rotors will start. If you want to switch off the rotors again, pull and
hold only the left control lever in the position "right/down".
• Now increase the rotating speed of quadrocopter rotors by pushing the left control lever forward slowly until the
quadrocopter takes off and hovers in front of you at a height of approx. 1.5 metres. Generally avoid any fast and
big controlling motions. Also watch closely to see whether and in which direction the quadrocopter moves. By using
trimming on the remote control (see item d) in this chapter), you can align undesired movements.
Figure 11
Figure 12
51