EB TECHNOLOGY START-S6XL BLOCK Notice D'emploi page 41

START-S6XL BLOCK
6.3 Learning of the remote controls
The remote controls can be learnt ONLY when the gate is CLOSED.
ALWAYS PERFORM THE LEARNING WITHOUT CONNECTING THE ANTENNA TO THE CLAMPS NO. 24-25
1
> > > > > > > > > > > > > >
2
CODES
3
START
> > > > > > > > > > > > > > >
1
CODES
> > > > > > > > > > > > > > > >
2
CODES
3
PEDESTRIAN
- If you need to learn a new remote control repeat the same operation.
- When you push the remote control's button and the L.E.D. codes is switched ON, it means that the remote control is not compatible
- When you push the remote control's button and the L.E.D. codes fl ashes slowly, it means that the memory is FULL.
- In this card is not previewed the cancellation of a single remote control's code.
7 Reset of the memory
The reset of the memory programm the standard values of the remote controls. It doesn't cancel the codes:
there are two diff erent memories.
TIMES CODES
LED L1
LED L1
TIMES CODES
Make sure that the gate is in CLOSED position
Press and release the CODES button, the LED L1 will stay lit.
Press the button of the remote control, ex: button no.1:
if it is memorized LED L1 will fl ash
Press and release the CODES button, the LED L1 will stay lit.
Press again the CODES button, the LED L1 will fl ash and stay lit
Press the button of the remote control, ex:
button no.2: if it is memorized LED L1 will fl ash
Press the buttons CODES and TIMES
1
LED L1 lit ON
2 Wait 10 seconds unitl LED L1 will switch OFF
3 Release the buttons CODES and TIMES
-17-
Technical manual