Using The Remote Controls - EB TECHNOLOGY START-S6XL BLOCK Notice D'emploi

START-S6XL BLOCK
6

Using the remote controls

This receiver can manage standard codes from 12 till 64 bit and rolling codes HCS©. The fi rst learned trans-
mitter establish the code's type taht the receiver has to manage, it means that the transmitter has to have the
same code's type. Concerning the rolling codes it is possible to activate or disactivate the key'scontrol and the
rolling counter. With this function you can choose the security level of the receiver.
6.1 FULL CANCELLATION of the memory
This operation cancels all previous memorized codes. It is not contemplated the cancellation of a single remote
control code. It is necessary to reset the memory before learning the fi rst remote control to avoid the remaining
of previously memorized codes that aren't in use in the installation. The cancellation of the memory (all codes)
is possible only when the gate is closed.
Make sure that the gate is in CLOSED position.
1
Press and keep pressed the CODES BUTTON
CODES
Wait for the LED L1 to start fl ashing, then release it.
2
Wait until the reset of the memory.
CODES
6.2 ROLLING CODE activated
Fixed code MODE (L1 - one fl ash)
The receiver manages standard codes from 12 to 64 bit and HCS© rolling code (only the fi xed part)
Complete rolling code (L1 - fl ashes twice):
You can control the rolling code counter and the remote cannot be duplicated
> > > > > > > > > > > > > > > >
1
CODES
> > > > > > > > > > > > > > 2
CODES
> > > > > > > > > > > > > > >
3
CODES
4
Press and release the button codes, LED L1 will lit on.
Press and release the button CODES again, LED L1 fl ashes and lit on
Press the button CODE again, LED L1 fl ashes twice,
it activate the rolling code counter.
To return to the fi xed code,
repeat the operation from point no.1 in this way LED L1 will fl ash only once.
-16-
Technical manual