Advanced Settings - EB TECHNOLOGY START-S6XL BLOCK Notice D'emploi

START-S6XL BLOCK
5.3

Advanced Settings

To programm the advanced setting, make as follow:
1 2
JP1
>
LED L1
TIMES
one fl ash
2 fl ashes
3 fl ashes
4 fl ashes
LED L1 - lit off
Function in OFF
LED L1 - lit on
Function in ON
>
LED L1
OFF / ON
CODES
JP1
1 Make sure that the gate is closed and JP1 closed, too.
LED L1 stops fl ashing, and the LED L1 of TIMES (times)
2
will fl ash according to the number of choosen functions.
The control unit make work the motor no.1 and no. 2 in the same
1 motor time. The program of the working time will be done only for motor
no. 1
"Death man"
The command START open, the PARTIAL OPENING closes.
function
Motors stops immediatelly when the button will be released
Industrial The Partial Opening became a closes contact and the
use START follow the logic of dip 1 and 2.
Soft-start When the gate is opening, the speed increases
After LED L1 has fl ashes for the choosen functions, LED will turned
3 off if the fucntion was in OFF position or it will lit on if the function
is in ON.
To change the ON-OFF position,
4
press and release the button CODES.
To return to the normal state,
5
bring JUMPER JP1 to OPEN
-15-
Technical manual