Setting The Ip Address; Activating The Outputs - Gorgy Timing RADIO TIMING 9s Mode D'emploi

4.4. SEttInG tHE IP aDDRESS

The first screen asks you whether you want
to set the RT9s's IP address manually.
If you want to set the RT9s's IP address, the
setting screen is displayed.
The first line is used to enter the IP address,
the second the subnet mask and the last the
default gateway

4.5. aCtIVatInG tHE OUtPUtS

This screen allows you to activate all the
outputs available on the RT9s.
The last two lines are used to specify the
time zone and the daylight saving time po-
licy (summer / winter) that will be applied to
the output time.
► Example: For France, if the local time is
entered, the last two fields must take the
following values:
► UTC : + 01H00
► DST : Europe
This screen displays whether the RT9s has
a pulse output. It can be used to indicate the
time on the pulse receiving clocks so that
the RT9s can automatically detect the num-
ber of pulses to send.
MDE-RT9s-3079V1.0 95