Rear Panel - HEADRUSH LOOPERBOARD Guide D'utilisation Rapide

Rear Panel

1. Power Input (19 VDC, 3.42 A, center-positive): Connect this input to a power outlet using the
included power adapter.
2. Power Adapter Restraint: Secure the power adapter cable to this restraint to prevent it from
accidentally unplugging.
3. Power Switch: Press this button to turn the HeadRush Looperboard's power on. Press and hold
this button to turn the HeadRush Looperboard's power off.
4. Vent: Make sure this vent is unobstructed while using the HeadRush Looperboard.
5. Inputs (XLR or 1/4"/6.35 mm, balanced): Connect your guitar, instrument, drum machine,
keyboard, or other audio source to these inputs. You can enable or disable +48V phantom power
for these inputs in the
Important: Only enable phantom power if your microphone requires it. Most dynamic microphones
and ribbon microphones do not require phantom power, while most condenser microphones do.
Consult your microphone's documentation to find out whether it needs phantom power.
6. Aux Input (1/8"/3.5 mm, TRS): Connect an optional audio source (e.g., smartphone, tablet, etc.)
to this input. Use the Aux knob to control the volume level.
7. Outputs (XLR): Connect these outputs to the inputs of your mixer, active loudspeaker, etc. Use
the Main knob to control the volume level. You can adjust the ground-lift setting for these outputs
in the Global Settings
8. Outputs (1/4"/6.35 mm, balanced): Connect these outputs to the inputs of your amplifier, audio
interface, mixer, etc. Use the Main knob to control the volume level. You can switch the level of
these outputs between Amp and Line in the
9. Phones Output (1/4"/6.35 mm, TRS): Connect stereo headphones to this output. Use the Phones
knob to control the volume level.
10. Expression Pedal Input (1/4"/6.35 mm, TRS): Connect an optional expression pedal to this input.
11. MIDI In (5-pin DIN): Use a standard MIDI cable to connect this input to the MIDI output of an
optional external MIDI device. See
12. MIDI Out/Thru (5-pin DIN): Use a standard MIDI cable to connect this output to the MIDI input of
an optional external MIDI device. You can set this output to be a standard MIDI output or MIDI
throughput in the
13. USB Type-B Port: Connect this USB port to a computer using a standard USB cable. This
connection allows the HeadRush Looperboard to send and receive the digital audio signal to and
from your computer. You can also use this connection to import or export loops, individual audio
files, backing tracks, etc. See
This connection is also used to update the firmware. Visit
firmware updates.
4
Global Settings
page.
External MIDI Control
Global Settings page.
USB Connection
page.
Global Settings
for more information.
headrushfx.com
page.
for more information.
to check for available