Stainless Steel Surfaces; Painted Surfaces; Control Panel - GE JGS905 Manuel Du Propriétaire

Stainless Steel Surfaces

Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface,
use warm sudsy water or a stainless steel
cleaner or polish. Always wipe the surface
in the direction of the grain. Follow the
cleaner instructions for cleaning the
stainless steel surface.

Painted Surfaces

Painted surfaces include the top and
sides of the door, and the drawer front.
Clean these with soap and water or
a vinegar and water solution.
Oven Vent
The oven is vented through an opening
in the cooktop under the grille.
Never cover the opening with aluminum
Center vent
foil or any other material. This would

Control Panel

If desired, the touch pads may be turned off
before cleaning.
See the Control Lockout section.
Clean up splatters with a damp cloth.
Removable Oven Floor
Oven floor
To remove the oven floor for easier
cleaning:
(on some models)
Remove the oven door using the
instructions in the Lift-Off Oven Door
section.
Grasp oven floor at the rear finger
slots on each side, lift it up, push it
back and pull it out.
www.GEAppliances.ca (Canada)
To inquire about purchasing stainless
steel appliance cleaner or polish, or to
find the location of a dealer or Mabe
Parts Store nearest you, please call our
toll-free number:
National Parts Center 1.800.626.2002 (U.S.)
1.800.661.1616 (Canada)
ge.com (U.S.)
www.GEAppliances.ca (Canada)
Do not use commercial oven cleaners,
cleaning powders, steel wool or harsh
abrasives on any painted surface.
prevent the oven vent from working
properly.
You may also use a glass cleaner.
Remove heavier soil with warm soapy
water. Do not use abrasives of any kind.
Turn on the touch pads after cleaning.
Clean the oven floor with warm
soapy water.
IMPORTANT: Always replace the
removable floor before the next use.
ge.com (U.S.)
27