GE JGS905 Manuel Du Propriétaire page 33

Problem
Control signals after
entering cooking time
or start time
Display goes blank
Display flashes
Unable to get the
display to show "SF"
Power outage,
clock flashes
"Burning" or "oily"
odor emitting from
the vent
Strong odor
Possible Causes
You forgot to enter a
bake temperature or
cleaning time.
A fuse in your home may
be blown or the circuit
breaker tripped.
The clock is in the
black-out mode.
Power failure.
Oven control pads were
not touched properly.
Power outage or surge.
This is normal in a new oven • To speed the process, set a self-clean cycle for a
and will disappear in time.
An odor from the insulation
around the inside of the oven
is normal for the first few times
the oven is used.
What To Do
• Touch the BAKE pad and desired temperature or
the SELF CLEAN LO/STD pad and desired clean time.
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
• Reset the clock.
• The BROIL HI/LO and BAKE pads must be touched at
the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must reset
it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
minimum of 3 hours. See the Using the self-cleaning
oven section.
• This is temporary.
ge.com (U.S.)
www.GEAppliances.ca (Canada)
33