GE JGS905 Manuel Du Propriétaire page 28

Cleaning the glass cooktop.
Clean your cooktop after
each spill. Use CERAMA
®
BRYTE Ceramic Cooktop
Cleaner.*
Use a CERAMA BRYTE ® Cleaning
Pad for Ceramic Cooktops.*
The CERAMA BRYTE ® Ceramic
Cooktop Scraper* and all
recommended supplies are
available through our Parts Center.
See instructions under "To Order
Parts" section on next page.
NOTE: Do not use a dull or
nicked blade.
28
Control Lockout
Begin by locking the cooktop; see the
Control Lockout section.
Normal Daily Use Cleaning
ONLY use CERAMA BRYTE
Cooktop Cleaner* on the glass cooktop.
Other creams may not be as effective.
To maintain and protect the surface of your
glass cooktop, follow these steps:
Before using the cooktop for the
first time, clean it with CERAMA
BRYTE ® Ceramic Cooktop Cleaner.*
This helps protect the top and makes
cleanup easier.
Daily use of CERAMA BRYTE
Cooktop Cleaner* will help keep the
cooktop looking new.
Burned-On Residue
WARNING: DAMAGE to your glass surface may
occur if you use scrub pads other than the pad
included with your cooktop.
Allow the cooktop to cool.
Remove the burner grates and vent
grille.
Spread a few drops of CERAMA
BRYTE ® Ceramic Cooktop Cleaner*
on the entire burned residue area.
Heavy, Burned-On Residue
Allow the cooktop to cool.
Remove the burner grates and vent
grille.
Use a single-edge razor blade scraper
at approximately a 45° angle against
the glass surface and scrape the soil.
It will be necessary to apply pressure
to the razor scraper in order to
remove the residue.
* For Canadian models, use a Mabe-approved equivalent when CERAMA BRYTE
Contact Mabe Replacement Parts to order replacement cleaning products.
® Ceramic Remove the burner grates and vent
grille.
Shake the cleaning cream well.
Apply a few drops of CERAMA BRYTE
Ceramic Cooktop Cleaner* directly to
the cooktop.
Use a paper towel or CERAMA BRYTE
Cleaning Pad for Ceramic Cooktops* to
clean the entire cooktop surface.
Use a dry cloth or paper towel to
® remove all cleaning residue. No need
Ceramic
to rinse.
NOTE: It is very important that you DO NOT heat
the cooktop until it has been cleaned thoroughly.
Using the included CERAMA BRYTE
Cleaning Pad for Ceramic Cooktops*,
rub the residue area, applying
pressure as needed.
If any residue remains, repeat the
steps listed above as needed.
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMA BRYTE
Ceramic Cooktop Cleaner* and a paper
towel.
After scraping with the razor scraper,
spread a few drops of CERAMA
BRYTE
the entire burned residue area. Use the
CERAMA BRYTE
remove any remaining residue.
For additional protection,
after all residue has been removed,
polish the entire surface with
CERAMA BRYTE
Cleaner* and a paper towel.
® Ceramic Cooktop Cleaner* on
® Cleaning Pad* to
® Ceramic Cooktop
® products are not available.
®
®
®
®