Bosch 700 Serie Notice D'installation page 4

,
Important safety Instructions
READ AND SAVE THESE INSTRUCTIONS
Before installing, turn power oFF at the service
panel. Lock service panel to prevent power from be-
ing turned ON accidentally.
remove all tape and packaging before using the
range. Destroy the carton and plastic bags after un-
packing the range. Never allow children to play with
packaging material.
never modify or alter the construction of a range
by removing leveling legs, panels, wire covers, anti-
tip brackets/screws, or any other part of the product.
Do not repair or replace any part of the appliance
unless specifically recommended in the manuals.
All other servicing should be done by a qualified
technician. This may reduce the risk of personal
injury and damage to the range.
to eliminate the risk of burns or fire by reaching
over heated surface units, cabinet storage space
located above the surface units should be avoided.
If cabinet storage is to be provided, the risk can be
reduced by installing a hood that projects horizon-
tally a minimum of 5" (12.7 cm) beyond the bottom
of the cabinet.
Verify that cabinets above the cooktop are a maxi-
mum of 13" (330 mm) deep.
Do not lift door by door handle. Remove the door
for easier handling and installation. See Section "Re-
moving Oven Door" in Use and Care manual.
It is the responsibility of the owner and the install-
er to determine if additional requirements and/or
standards apply to specific installations.
electric safety
before you plug in an electrical cord, be sure all
controls are in the oFF position.
be sure your appliance is properly installed and
grounded by a qualified technician in accordance
with the National Electrical Code ANSI/NFPA 70 lat-
est edition and local electrical code requirements.
(In Canada, installation must be in accordance with
the CAN 1-B149.1 and .2 Installation Codes for Gas
Burning Appliances and/or local codes).
Important: Local codes vary. Installation, electrical
connections and grounding must comply with all ap-
plicable codes.
4
For appliances equipped with a cord and plug, do not
cut or remove the ground prong. It must be plugged
into a matching grounding type receptacle to avoid
electrical shock. If there is any doubt as to whether
the wall receptacle is properly grounded, the custom-
er should have it checked by a qualified electrician.
If required by the national electrical code (or
Canadian Electrical Code), this appliance must be
installed on a separate branch circuit.
Only a power-supply cord kit rated for this appli-
ance and marked "for use with ranges" shall be
used.
Installer – show the owner the location of the cir-
cuit breaker or fuse. Mark it for easy reference.
Important – save these instructions for the local
electrical inspector's use.
Installation, electrical connections and grounding
must comply with all applicable codes.
gas safety
Install a gas shutoff valve near the appliance. It
must be easily accessible in an emergency.
leak testing must be conducted by the installer ac-
cording to the instructions in this manual.
the appliance and its individual shutoff valve must
be disconnected from the gas supply piping system
during any pressure testing at pressures in excess of
½ psi (3.5 kPa).
the appliance must be isolated from the gas sup-
ply piping system by closing its individual manual
shutoff valve during any pressure testing of the gas
supply piping system at test pressures equal to or
less than ½ psi (3.5 kPa)
the minimum supply pressure must be 1 inch water
column above the manifold pressure printed on the
data plate
the maximum supply pressure must not exceed
14 inches water column (34.9 Millibars).
Do not store or use combustible materials, gasoline
or other flammable
vapors and liquids in the vicinity of this or any other
appliance