Maintenance And Storage - KRATOS SAFETY FA 60 023 20 Mode D'emploi

The device is for use with a fall arrest system as defined in the product data sheet (see standard EN363) to guarantee that the dynamic force exerted
on the user during the arrest of a fall is no greater than 6kN. A fall arrest harness (EN361) is the only body gripping device that may be used. It can be
dangerous to create one's own fall protection system in which each safety function can interfere with another safety function. Therefore, it is important
to read the recommendations on using each component in the system before use.
INSPECTION:
The recommended service life of this product is unlimited (in accordance with the annual examination by a competent person authorised by KRATOS
SAFETY), but it may be reduced according to use and/or the results of the annual inspections. The equipment should be inspected if there is any doubt,
or following a fall, and at least annually, by the manufacturer or a competent person and in strict compliance with the manufacturer's periodic inspection
procedures (and in particular the inspection guides ref. GI XX-XXXXXX-XX) to check its strength and therefore the user's safety. If the WINCH is
used for load lifting, the checks are carried out every 6 months.
The product data sheet should be completed (in writing) after each verification. The date of inspection and date of the next inspection must be indicated
on the data sheet. It is also recommended to put the date of the next inspection on the product.
MAINTENANCE AND STORAGE: (These instructions must be strictly observed)
During transportation, keep the equipment away from any cutting edges and keep it in its packaging. Clean with water, wipe with a cloth and hang in a
ventilated room to dry naturally, ensuring that it is away from any direct light or source of heat; the same applies for elements that may have become wet
during use. The system must be stored in its packaging in a dry, well aired place protected from extremes of temperature.
8