Progr.sett (Weekly Setting); Stand-By Mode - Cadel Nice Manuel D'installation Et Utilisation

5.14. PROGR.SETT (weekly setting)

not to be activated if in 5.15 "STAND-BY" mode
Ignition and turning off the stove can be programmed day by day for seven days with 2 daily stages
(PROGRAM 1 and PROGRAM 2). Remember that button P4 can be used to quit programming at any
time. The parameters for the chronothermostat are as follows:
UT01
UT02
UT03
UT04
UT05
UT06
UT07
UT08
UT09
UT010
To see if the chronothermostat is active, check the items "Day" (active) on UT1 and "OFF"(deactivated).
Below there are details of the meaning of some parameters.
UT01: is used to enter the weekly program in "Day" or exclude it if in "Off". Select the day of the week
from "Day1", which corresponds to Monday, to "Day7", which is Sunday. If the UT01 parameter is set with
current day (e.g. Day2, i.e. Tuesday) you can select the day of the week to associate ignition with
PROGRAM 1 and/or PROGRAM 2. Press buttons P1 and P2 to select the desired value.
UT05-UT06: indicate the start and finish times to ignite the stove in PROGRAM 1. These settings are
active if the UT01 parameter is set on weekly mode.
UT07: this parameter is active when parameter UT01 is set on weekly mode. When PROGRAM 1 is active,
use the P1 button to select the day of the week and the P2 button to activate/deactivate stove ignition.
UT08-UT09: indicate the stove start and finish time in PROGRAM 2. The settings are active if the UT01
parameter is set on weekly mode.
UT010: this parameter is active when the UT01 parameter is set on weekly mode. When PROGRAM 2 is
active use the P1 button to select the day of the week and the P2 button to activate/deactivate stove
ignition.

5.15. STAND-BY MODE

not to be activated if in 5.14 "PROGR.SETT" mode
The STAND-BY mode activates a function that starts turning off if the ambient temperature setting has
been exceeded by more than 2/4°C.
automatically starts itself. To set, press button P3 until you reach UT04, use P1 to find the value of 99,
press P3 and set the degree delta (3°C degrees advisable); if the value is 0° the function is deactivated.
MIRIAM-NICE-DIANA-PRETTY-MARY
Sets current day and mode.
Sets current hours.
Sets minutes.
Sets technical parameters (reserved)
Sets ignition time PROGRAM 1
Sets turning off time PROGRAM 1
Selects the days of the week with stove ignition in the morning.
Sets ignition time PROGRAM 2.
Sets turning off time PROGRAM 2.
Selects days with stove ignition in the afternoon.
If the ambient temperature drops by over 2/4°C the stove
(see paragraph 5.15)
(see paragraph 5.14)
Pag. 77