Video Matrix Sw328; Description; Connection; Matrix Setup - Videotec DCK Manuel D'instructions

5.8 Video ma trix SW328

5.8.1 Description

Matrix SW328 is a product for professional use in applications for security and surveillance and dedicated to the
management of video signals. It can be used to control 32 input videos; there are eight video outputs, one of
which can be managed directly by a VCR. It is used to control the usual switching and alarm management
operations. Refer to the matrix manual for further information on this subject.

5.8.2 Connection

5.8.2.1 Cable
The communication cable is standard, as described in § 3.3 - Standard connection cable, page 8.
5.8.2.2 Matrix setting s
No setting is necessary.
5.8.2.3 Keyboard set tings
While the keyboard is being set up, the
follows:




The presence of more keyboards connected to the switcher means it is necessary to define a different
identification number for each (from 1 to 8).
5.8.2.4 Operational t est
If the keyboard is connected directly with the switcher set up in this way using the telephone cable supplied, it
should be possible to switch the input videos immediately:

• press

• press
Warning! Matrix SW328 can be set up so as to exclude control by the keyboard during certain periods of
the day or in specific situations. In this case switching will be impossible. Refer to the respective
manual.
5.8.3 Matrix setu p
A remote keyboard can only set date and time on matrix SW328
To change date and time press

Key : move the cursor to the next position

Key : move the cursor to the previous position
 
Keys / : increase/decrease the value.

Control of a SW328 matrix
The baud rate is fixed at 9600 baud.
to select monitor 1

, , to select the cameras.

.
Page 24
submenu should be set as
MNVCDCK_0441