Accepting Requests For Cameras; Default Setting; Modifying The List - Videotec DCK Manuel D'instructions

Shown on display


4.4 Accepting requests for cameras

Accepting requests for cameras allows keyboard use to be limited solely to authorised input videos without
having to use further system passwords. We recommend defining the accepted input video groups for each
keyboard only after clearly defining the system configuration.
Accepted cameras makes use of a two-level menu:



4.4.1 Default sett ing
The default setting allows control of all cameras, erasing any previously defined setting.
4.4.2 Modifying t he list
Modify list allows more precise definition of the list of cameras that can be requested from the keyboard.
The modify list menu displays the various sets of cameras to be set up:




It is important to note the three special symbols on the right of the display:
indicates that no camera in the corresponding set is accepted

indicates that some cameras in the set are accepted and some are not

indicates that all cameras in the set are accepted.

There are 9999 cameras available: normally a much smaller set of cameras will be used but the possibility of
selection over a wide interval is useful for video management with large sized devices where the "zone" feature
is available.
The display in the example shows three sets of cameras: the first from number 1 to number 1000; the second
from number 1001 to 2000, the third from 2001 to 3000.
The other groups of cameras can be selected by the keys
The cursor shows the set of cameras being set up:

• to accept the request for all the cameras in the set press
• to disable all the cameras in the set press
• if the set of accepted cameras is to be defined more precisely (some cameras in the set should be accepted
and others not), press

• press
to return to the previous display menus.
The following example shows how to accept cameras 1 to 7, and at the same time disable access to all the
others:
Submenu











to subdivide the set shown into smaller sets.
Description
Changes display contrast: press


recalls the previous contrast value and

recalls the default value.
Resets factory default values. The reset
operation should be confirmed by the
operator.
Saves new settings and exits menu.

(previous) and

.
.
Page 12

to alter

(next)
MNVCDCK_0441
and
contrast.