General Safety Terms And Protection Measures - ASO Safety Solutions ISK 76-21 Manuel D'utilisation

General Safety Terms and Protection Measures

• It is the responsibility of the manufacturer and operator of the plant/machine, on which the
safety system is used, to observe and fulfil all valid safety regulations and rules.
• The safety system guarantees a functional safety, in conjunction with the machinery control
system, however this does not apply to the complete safety of the plant/machine.
Therefore, a safety consideration for the complete plant/machine, according to the European Standard
EN 13241-1 "Industrial, commercial and garage doors and gates", is necessary before using this safety
system.
• This manual must be available at the installation place of the safety controller at all time.
Any person assigned with the operation and maintenance of the safety system must read and
follow this manual.
• The safety system may only be installed and initially operated by qualified personnel, who are
familiar with this manual and the valid regulations for safety at work and accident prevention.
The instructions in this manual must be strictly taken into consideration and fulfilled.
Electrical work may only be carried out by qualified personnel.
• All electrical engineering and the professional organizations safety regulations are to be considered.
• Before performing any work on the safety controller, the voltage must be disconnected and verified
that there is no live voltage.
• If the potential free contacts of the relay outputs are connected to a dangerous voltage, it is also
necessary to switch off this voltage before working on the safety controller.
• The safety controller contains no user-serviceable parts. Any unauthorised modifications and/or
repairs of the safety controller will terminate any guarantee and claim against the manufacturer.
• The safety system is to be checked in proper time intervals by qualified personnel, and must be
documented in such a way that it can be viewed and understood at any time.
For a standardized-conformal construction of the safety system accord-
ing to EN 12543 "Safety in use of power operated doors - requirements"
and EN 12978 "Safety devices for power operated doors and gates",
the gate control system must perform a safety system test prior to
dangerous movements of the gate. The operation or the installation of
the safety controller ISK 76-21 does not fulfil any safety requirements
without being tested.
The liability of the manufacturer is terminated with neglect or deliberate
abuse.
1