Cross Support Assembly; Grid Supports & Wire Grids - NewAge Products Pro Serie Mode D'emploi

4ft Cross Support Assembly
(i) Assemble the 4ft Cross Supports (#13) with one 1/4" hex bolt (#17) and 1/4" lock nut (#18). (ii)
20
Attach the assembled 4ft cross supports to the perimeter frame with four hex bolts (#17), eight
washers (#9), and four lock nuts (#18)
Grid Supports & Wire Grids Installation
(i) Begin at the side ends of the Wall Mounted Shelves and slide the 4ft Finishing Grid Section with
21
bent edges (#11) . The bent edges would slide below the installed Pulley & Cables. (ii) Place 4ft "U"
Shaped Grid Supports under wire grid (#14).
i
i
ii
ii
21