Connecting Wall Mounted Shelf Vertically - NewAge Products Pro Serie Mode D'emploi

Connecting Wall Mounted Shelf Vertically

Fully Install upper wall shelf according
1
to option A (Wall Mounted) or B
(Ceiling Mounted). Start installing
lower wall shelf up until Step 8 on
Page.14
Continue assembly of the lower Wall Mounted Shelf by following the Ceiling Mounted
3
Option (Option B) throughout the install guide. Install back hanging brackets on the same
stud as above Wall Mounted Shelf.
Note: Diagram shows installing two Wall
mounted Shelves of the same size
Complete the Cable Assembly by installing the Cable Eyelet according to the distance measured
4
from the bottom of the upper Wall Mounted Shelf to the bottom of the lower Wall Mounted Shelf.
(Similar to step 9b pg.17)
5
Continue assembly according to Wall Mounted Shelf installation instructions, resuming on step 12.
28
Once you have followed steps 1 to 8 for the
2
lower wall shelf, install the pad eye plates on
your upper wall shelf according to diagram
below. You may need to remove the end
grids to access the mounting holes.
Using two 1/4" hex bolts, four 1/4" washers
and two 1/4" lock nuts, bolt a pad eye plate
to the mounting holes furthest away from
the wall. Repeat to the opposite side.
Note: Diagram shows installing 2ft deep
wall mounted shelf to 4ft deep wall shelf.
Note: For
connecting
2ft deep Wall Shelf
below