Grant GD100 Instructions D'utilisation page 8

PF5 for P5 plastic tank
Plastic lids
PL12 for P12 plastic tank
PL18 for P18 plastic tank
Hinged lids (These lids are supplied with hinges for fitting lid to bath)
LG12 for S18 stainless steel tank
LG26 for S26 stainless steel tank
LG38 for S38 stainless steel tank
The lid pack contains:
Lid (with upper part of hinge fitted)
2 hinges, (lower half )
4 screws
Assembly Instructions:
Remove the four bungs from the side of the bath. Attach the support brackets
and lower half of the hinges to the bath with the screws provided, but do not
tighten screws. Position the lid on the bath and check that lid opens smoothly
and is correctly lined up with the side of the bath before tightening screws.
Lid operation:
The lid can be opened by lifting the stainless steel handle at the END of the lid
and rotating it around the hinge, or removed by lifting the lid upwards slightly
using the handle on the TOP of the lid and moving it away from the hinge.
Polypropylene spheres:
A pack of spheres (PS20) is sufficient to give a single layer for a surface of
1000 cm2 .
17090 Version 15 - June 2009 83S
Page 7
www.grant.co.uk
GD100, GD120
Operating Manual