Safety - Grant GD100 Instructions D'utilisation

The following symbols mean:-
Caution: Read these operating instructions fully before use and pay particular attention to
sections containing this symbol
Caution: Surfaces can become hot during use.
Always observe the following safety precautions
Use only as specified by the operating instructions, or the intrinsic protection may be impaired.
After transport or storage in humid conditions, dry out the unit before connecting it to the supply voltage.
Connect only to a power supply with a voltage corresponding to that on the serial number label.
Ensure that the mains switch and isolating device (power supply connector) are easily accessible during
use.
Connect only to a power supply which provides a safety earth (ground) terminal.
Before moving, disconnect at the power supply socket.
Do not check the temperature by touch, use the temperature display (where applicable) or a
thermometer.
To reduce the risk of eye injury during high temperature operation, use safety goggles or spectacles.
Do not touch surfaces which become hot during high temperature operation.
Ensure that the operating temperature is less than the maximum operating temperature of your sample
material.
Do not block or restrict ventilation slots.
If liquid is spilt inside the unit, disconnect it from the power supply and have it checked by a competent
person.
It is the user‟s responsibility to carry out appropriate decontamination if hazardous material is spilt on or
inside the equipment.
GD100, GD120
Operating Manual
www.grant.co.uk

1. Safety

17090 Version 15 - June 2009 83S
EN
Page 2