Safety - Grant QBA Mode D'emploi

The following symbols mean:-
Caution: Read these operating instructions fully before use and pay particu-
lar attention to sections containing this symbol.
Caution: Surfaces can become hot during use.
Always observe the following safety precautions
Do not check the temperature by touch. Use a thermometer.
Do not touch surfaces which become hot during high temperature operation.
Use only as specified by the operating instructions, or the intrinsic protection may
be impaired.
To reduce the risk of eye injury during high temperature operation, use safety gog-
gles or spectacles.
After transport or storage in humid conditions, dry out the unit before connecting it
to the supply voltage. During drying out the intrinsic protection may be impaired.
Connect only to a power supply with a voltage corresponding to that on the serial
number label at the rear of the unit.
Ensure that the mains switch and power plug are easily accessible during use.
Connect only to a power supply which provides a safety earth (ground) terminal.
Before moving, allow to cool and disconnect at the power supply socket.
If liquid is spilt inside the unit, disconnect it from the power supply and have it
checked by a competent person.
It is the user's responsibility to carry out appropriate decontamination if hazardous
material is spilt on or inside the equipment.
Clean the unit only with a damp cloth. Do not use chemical cleaning agents.
Before using any cleaning or decontamination method except those recom-
mended in this manual, users should check with Grant Instruments that the pro-
posed method will not damage the equipment.
The unit must be placed on a level, non-flammable surface away from flammable
materials and ensuring that all ventilation slots in the base are clear from obstruc-
tions.
Disconnect the mains before removing the outer cover. Note there are no user
serviceable parts inside in the unit.
Use appropriate vessels / tubes for temperature required.
The unit is for indoor use only. Check that the environmental conditions of the
laboratory are within the limits given in Section 5.
Do not use in fume cupboards containing corrosive atmospheres.
QBD, QBA, QBH,
Operating Manual
www.grantinstruments.com

1. Safety

28089 Ver 12
Page 2
EN