Everyday Hot Tubs Marble Guide D'installation Et D'utilisation page 34

6. TROUBLE SHOOTING
6.1. Troubleshooting
Here are some useful tips to help you to diagnose and rectify common sources of
trouble.
Problem
Control panel
screen does not
operate
SPA pump does not
heat properly
Bubble massage
system does not
work
Water filtration does
not work
Pump leakage
Spa pool leakage
Water is not clean
The screen dis-
plays CHG FIL
!
34
Cause
Check power source
Temperature set is too low
Filter Cartridge is dirty
Too low water level
Heating element defective
Pump is overheating
Auto shut-down feature (30min) is
activated
Malfunction of the pump unit
Filter Cartridge is dirty
Inlet and outlet blocked
Air inside the pump
Malfunction of the pump unit
Adaptor seal improperly
Water leakage from pump body
Spa pool is torn or punctured
Insufficient filtering time
Filter Cartridge is dirty
Pool filled water quality
Improper water treatment
The filter has spent 150 hours of use
IMPORTANT
For any question or failure of your product, contact
your Cash Piscine store.
List of stores on www.cash-piscines.com
Solution
Power failure
Reset the RCD plug / Check if the wiring system is adapted to
the power of the pump unit (1540W)
Call for service if it does not reset
Set to a higher temperature
Clean or Replace the cartridge (see chapter 5.2)
Fill water to minimum water level
Call for service
Cut off the power and wait until the pump has cooled.
Press the bubble button to reactivate
Call for service if it does not reset
Clean or Replace the cartridge (see chapter 5.2)
Clean the inlet and outlet
Fill water to minimum water level
Call for service if it does not reset
Replace the seal in the right position
Check the pump body, call for service
Use provided repair kit (see chapter 5.4)
Increase the filtering time
Clean or Replace the cartridge (see chapter 5.2)
Change the pool water completely
Refer to the chemical manufacturer's instructions
Change the filter and press the filter button for 5s