Control Panel; Functions - Everyday Hot Tubs Marble Guide D'installation Et D'utilisation

4. USAGE

4.1. Control panel

Heater
Level of massage
Massage
Filtration

4.2. Functions

Once powered-up, the LED displays the current water temperature automatically.
The temperature units selector changes the temperature units from Celsius degrees to Fahr-
enheit degrees.
Press the temperature adjustment buttons, then the screen will flash. When it is flashing,
you can set the desired temperature. The value will increase or decrease 1 degree at once.
The temperature could be set between 30°C to 42°C (86°F to 107°F).
To lock or unlock the control panel, press the Lock button and hold 3 seconds.
Lock the control panel when you are away to prevent other people come to change
your settings..
Press the massage button to activate the bubble massage system, the green indicator light
turns on. It can be turned off by pressing it again.
Note :
- The massage system will stop automatically after 30 minutes of operation. Re-activate the massage function by
pressing the massage button again.
- When filter button is on, pressing bubble button will exchange filter mode into massage mode: filter indicator
light will turn off and massage indicator light turn on. If press the bubble button again, the massage mode will be
changed back to filter mode.
Press the filter button to activate the water filtration. The green indicator light will turn on
when the filtration system is activated.
Note:
- If massage function is on, the filtration can't be activated.
28
Anti freezing
Lock control
panel
LCD screen
Temperature
units indicator
WiFi
Increase
temperature
Temperature
units
selector
Decrease
temperature
programming