Everyday Hot Tubs Marble Guide D'installation Et D'utilisation page 27

The number of persons required for installation: 1 adult at least.
3.3. Assembling
1) Unfold the inflatable spa over the
base protector.
4) Insert the inflation hose into the
inflatable spa
7) Check the tightness of the valve
then close the valve cap.
10) Ensure that the drain caps are
properly closed before before filling
the spa
Warling : Do not leave spa unattended while filling with water.
Make sure the drain fitting is plugged securely and the cap is in place. Start filling the spa with water. After
about 1-inch of water is on the bottom, stop filling and smooth wrinkles out of the bottom of the spa. Pull
the outer wall out from the top edge, all around the bottom of the spa, so that it fills evently.
15 minutes for site preparation and water filling.
2) Bring the pump unit to the inflatable
spa.
5) Connect the pump unit then press
the button to inflate the spa.
No other mode should be activated.
Do not plug the holes in the inflation
hose to avoid over-inflation.
8) Connect the unit pump to the pool
using the 3 connectors to screw.
Ensure the icons on the pump and the
pool match up
11) Fill the spa with 10 cm of water.
Continue filling the spa until waterf level.
3) Connect the inflation hose to the
pump on the socket .
6) Inflate the structure for 3-4 minutes
until the gauge reads 4 psi.
9) Remove the 2 caps then put the
filter support on the filter cartridge
and screw it on the bottom suction
connection inside the basin.
12) Smooth wrinkles out of the bottom
of the spa, then fill the spa to the level
indicated. Your spa is ready.
EN
27