Everyday Hot Tubs Marble Guide D'installation Et D'utilisation page 31

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.4. Pairing your spa
Long press the WiFi button until the button flashes rapidly.
Open the Spa Controller (eco) application and, in the menu, click on «SETUP A
NEW SPA»
Scan the QR CODE located inside the back hatch of the spa (where the filtration
cartridges are stored)
Enter the information of your WiFi network.
In your phone settings, connect to the "Bath_Wi_Fi_XXXXXX" WiFi corresponding
to your spa,
Then go back to the application and click on «Start the configuration» and wait a
few minutes.
The WiFi link is established once the WiFi button is fixed.
4.5. Use
Parameters
Relaxing bubble mode
Turn relaxing bubbles on or off
Heating mode
Activate or deactivate the
Filtration Mode
Activate or deactivate filtration
Temperature button
change the spa temperature
heating.
Timer mode
Choose the time before which
the heating must start
Lock button
Lock the control panel
Antifreeze button
Activate or deactivate the
antifreeze mode
On / Off button
EN
31

Publicité

Table des Matières
loading

Table des Matières