Site Selection - Everyday Hot Tubs Marble Guide D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. INSTALLATION
WARNING : Spa installed on inadequately level surfaces are subject to leaking. forming irregulari-
ties or collapses. which can result in properly damage or serious injury for those in or around the spa
area!
CAUTION : Please choose your set-up area carefully as lawn and other desirable vegetation
undereath the ground cloth (if applicable) wil die. furthermore, try to avoid setting the ground cloth in
areas prone to aggressive plant and weed species, as they may grow trough the ground cloth.

3.1. Site selection

WARNING : Before proceed to installation your spa, please make sure that the future location
meets the following conditions :
A level place in order to avoid any defect, hernia or leakage.
Wide enough to support the pool and its pump unit.
Able to support more than 500 kg/m².
Sheltered from the sun and bad weather.
Clean, devoid of roughness and water resistant.
Devoid of aggressive vegetation on the ground.
Failure to comply with these rules may result in property damage or personal injury.
A place with an awning
3.2. RCD test
WARNING: The RCD plug must be tested before each use..
Do not use if RCD test fails and see chapter 6.1.
1. Insert the plug into the
power outlet.
Once the spa is plugged in and turned on, if the ground connection is correct, the motor unit emits
a "beep", then the temperature is displayed.
If the ground connection is not correct, the motor unit displays GND, in this case, check that your
electrical installation has a ground connection, or manually connect the motor unit.
Grounding
You are recommended to use the services of a qualified electrician to ensure that the spa is elec-
trically grounded by using a copper conductor of at least 2.5 mm² cross section.
26
Clean the place
2. Press the «RESET» button,
the indicator light turns red.
3. Press the «TEST» button,
the indicator light turns off.
A level place
4. Press the «RESET» button,
the indicator light turns red.
The RCD works properly.

Publicité

Table des Matières
loading

Table des Matières