Everyday Hot Tubs Marble Guide D'installation Et D'utilisation page 29

Press the heating button to activate water heating and filtering system at the same time. The
green indicator light of filter and red indicator light of heating will turn on at same time
The pump does not stop heating until the current water temperature reaches the set temper-
ature (The red light flashes once the temperature is reached). The heating system will re-
start after the current water temperature drops 2°C below the set temperature automatically.
Maximum heating temperature: 42°C (107°F)
Important :
After 150 cumulative hours of filtration operations, an audible alarm will sound and
the LCD display will show the characters CHG, followed by FIL, to remind you to
change and clean the filter. You can hold the filtering button 5 seconds to turn off
the buzzing. The filtering system will turn off, you can press the button to active the
filtering system again.
Note :
- The heating system is dependent on the filtration system and it can operate without.
- After turning off the heating system, the filtration system will still work.
- If the massage function is active, the filtration and heating functions cannot be activated.
- The engine block is designed to operate 24 hours a day.
- The spa cannot be connected to a programmer because of its electrical protection.
The massage level button allows you to switch to one of three massage speeds to choose
from. Press the button several times to choose the desired speed.
The anti-freeze button keeps the water in your spa at a temperature above 5 ° C. When the
anti-freeze is activated, if the water temperature drops below 5 ° C, the heating will turn on
to raise the water temperature to 10 ° C.
The programming button allows you to start heating the spa within a predefined time
interval. When the spa is in operation, press the programming button to indicate when the
heating should come on.
The WiFi button is used to launch the spider with
4.3. Pool cover and security
After each use, the control panel must be locked and the pool must be coated with its
top cover and it must be attached to the base protector
with the safety buckles.
Each safety buckles has a lock system ; closed buckle,
the latch in up position locks the buckle, the latch in down
position unlocks the buckle.
The top cover keeps the heat from the water and secures the
pool.
EN
29