Haier HLTD500AEW Manuel D'utilisation page 13

GAS DRYER
ELECTRICAL SUPPLY REQUIREMENTS
The gas dryer must be plugged into a properly grounded 3-wire, single
phase, 120 volt, 60Hz, AC-only electrical outlet, fused with a 15-amp
time-delay fuse or circuit breaker.
The dryer is equipped with a power cord that has a 3 prong plug. Do not cut or
remove the grounding prong from the power cord.
The power cord must be plugged into a mating, 3 prong outlet, grounded in
accordance with local codes and ordinances. If a mating outlet is not available,
contacted a licensed electrician to have one installed.
If you are not sure if your outlet is properly grounded, contact a licensed
electrician.
Do not use a 3 prong plug adapter.
Do not use an extension cord.
WARNING
11