Work Area Safety; Electrical Safety; Personal Safety - Bosch GLL 2-20 Consignes De Fonctionnement/Sécurité

Work Area Safety

Keep work area clean and well lit. Cluttered
or dark areas invite accidents.
DO NOT operate the laser tool around
children or allow children to operate the
laser tool. Serious eye injury could result.

Electrical Safety

Batteries can explode or leak, cause injury
or fire. To reduce this risk, always follow all
instructions and warnings on the battery
label and package.
DO NOT short any battery terminals.
DO NOT charge alkaline batteries.
DO NOT mix old and new batteries. Replace
all of them at the same time with new
batteries of the same brand and type.
DO NOT mix battery chemistries.
Dispose of or recycle batteries per
local code.
DO NOT dispose of batteries in fire.
Keep batteries out of reach of children.
Remove batteries if the device will not be
used for several months.

Personal Safety

Stay alert, watch what you are doing and use
common sense when operating a tool. Do
not use a tool while you are tired or under the
influence of drugs, alcohol or medication. A
moment of inattention while operating a tool
may result in serious personal injury or incorrect
measurement results.
Use safety equipment. Always wear eye
protection. Safety equipment such as dust
mask, non-skid safety shoes, hard hat, or
hearing protection used for appropriate
conditions will reduce personal injuries.
Positioning Device
Keep the Positioning Device
12 and Laser Target Plate
22 away from cardiac
pacemakers. The magnets (17
and 24) generate a field that can
impair the function of
cardiac pacemakers.
Keep the Positioning Device 12 and Laser
Target Plate 22 away from magnetic
data medium and magnetically-sensitive
equipment. The effect of the magnets (17 and
24) can lead to irreversible data loss.
Use the correct tool for your application. The
correct tool will do the job better
and safer.
Do not use the tool if the switch does not
turn it on and off. Any tool that cannot be
controlled with the switch is dangerous and
must be repaired.
Store idle tool out of the reach of children
and do not allow persons unfamiliar with
the tool or these instructions to operate
the tool. Tools are dangerous in the hands of
untrained users.
Maintain tools. Check for misalignment or
binding of moving parts, breakage of parts
and any other condition that may affect the
operation. If damaged, tool repaired before
use. Many accidents are caused by poorly
maintained tools.
Use the tool, accessories, etc., in accordance
with these instructions and in the manner
intended for the particular type of tool, taking
into account the working conditions and the
work to be performed. Use of the tool for
operations different from those intended could
result in a hazardous situation.
Have your tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the tool is
maintained.
Develop a periodic maintenance schedule
for tool. When cleaning a tool be careful not
to disassemble any portion of the tool since
internal wires may be misplaced or pinched or
may be improperly mounted. Certain cleaning
agents such as gasoline, carbon tetrachloride,
ammonia, etc. may damage plastic parts.
SAVE THESE INSTRUCTIONS.
-7-
Use and Care
Service