Replacing The Door Seal; Cleaning Self-Cleaning Surfaces; Maintenance - Bosch 800 Serie Mode D'emploi

Replacing the Door Seal

Loosen the clips at the four corners and in the center,
1.
and remove the seal.
Hook the new seal onto the four corners first and then
2.
in the center.

Cleaning Self-cleaning Surfaces

CAUTION
9
Do not use oven cleaner on the self-cleaning
surfaces. These will damage the surfaces. If oven
cleaner does get onto these surfaces, dab it off
immediately using water and a sponge cloth. Do not
rub the surface and do not use abrasive cleaning
aids.
Use a microfiber cloth with soapy water to clean the
1.
upper and lower part of the self-cleaning surfaces.
Set the bake burner to the highest temperature.
2.
Press to switch on air recirculation.
w
3.
Switch off the appliance after one hour.
4.
If the side, self-cleaning surfaces are particularly dirty,
5.
remove these from the cooking compartment.
Note: The self-cleaning surface on the back panel
must remain in the cooking compartment.
Wash the self-cleaning surfaces with hot soapy water.
6.
Rinse and dry the self-cleaning surfaces.
7.
Insert the self-cleaning surfaces into the cooking
8.
compartment.
Set the bake burner to 350°F.
9.
Press to switch on air recirculation.
w
10.
Switch off the appliance after one hour.
11.

Maintenance

How to Remove the Rack Guides and Self-cleaning
Surfaces
The rack guides are fixed to the side panels of the
cooking compartment at three points. The self-cleaning
surfaces are fixed with the rack guides.
When the oven is cool, grip the front of the rack guide
1.
and pull it round to the middle of the cooking
compartment.
The front hook of the rack guide will come out of the
hole.
Swing the rack guide round further and pull it out of
2.
the rear holes in the side panel.
Remove the rack guides from the cooking
3.
compartment.
Replace the self-cleaning surfaces and rack guides in
4.
the reverse order in which they were removed.
How to Remove the Oven Door Glass
WARNING
9
Make sure oven is cool and power to the oven
▯
has been turned off before removing the door.
Failure to do so could result in electrical shock or
burns.
The glass panels are big, heavy and parts are
▯
fragile. Use both hands to remove the glass.
Handle carefully to avoid breakage.
Failure to grasp the glass firmly and properly
▯
could result in personal injury or product damage.
Do not place the glass on sharp or pointed
▯
objects as this could break the glass. Lay on a
flat, smooth surface, positioned so that the glass
cannot fall over.
CAUTION
9
Wear gloves to avoid cutting fingers on broken
glass.
For easier cleaning the internal glass panes of the door
can be removed.
27