Teac AG-10D Manuel Du Propriétaire page 90

90
All manuals and user guides at all-guides.com
Cannot listen to any station, or signal is too weak.
Though the broadcast is stereo, it sounds monaural.
Remote control doesn't work.
If normal operation cannot be recovered, unplug the power cord
from the outlet and plug it again.
Troubleshooting 2
e Make sure the antenna is properly connected.
e Tune in the station properly.
e If a TV is near the unit, turn it off.
e Install the antenna again after relocating it to a better
reception position.
e An external antenna may be required.
e Press the FM MODE button.
e Select the component to be controlled by pressing the
REMOTE SELECT buttons (RECEIVER, CD, AUX, TV, VCR,
DVD, CABLE, SAT) of the remote control unit. (Even when
the REMOTE SELECT buttons are pressed without pointing at
the main unit, the selection of the remote control unit will be
changed.)
If you want to control the receiver, first press the RECEIVER
button, and then press buttons to operate.
e Press the POWER switch of the main unit to turn it standby.
e If the batteries are dead, change the batteries.
e Use remote control unit within the range (5m) and point at
the front panel.
e Clear obstacles between the remote control unit and the
main unit.
e If a strong light is near the unit, turn it off.
ENGLISH