Teac AG-10D Manuel Du Propriétaire page 48

1
1
FL C
DTS L
2
48
All manuals and user guides at all-guides.com
2
FR SR SB SL
DD L SW
Speaker Configuration 5
Balancing relative volume between speakers
during playback of DVD
1 (During playback of DVD,) press the CH SEL (CHANNEL
SELECTOR) button.
Each time the CH SEL button is pressed, the channel is
changed as follows:
If the balance has already been set using the test tone
function, you don't have to change the setting of speakers (FL,
C, FR, SR, SL, SW).
If you want to change the LFE level for Dolby Digital or DTS,
press the CH SEL button repeatedly until "DD L (Dolby Digital
LFE)" or "DTS L (DTS LFE)" appears on the display.
(LFE: Low Frequency Effect)
< A speaker set to "None" or "No" will not appear on the display.
< When STEREO or Dolby Virtual is selected, or when the
SPEAKER button is set to off, only the front speakers will
appear on the display.
2 Within 5 seconds, press the LEVEL buttons to change the
level.
< The level of speakers can be adjusted in 1 dB steps from -15
dB to +15 dB.
< The LFE level can be adjusted in 1 dB steps from -10 dB to 0
dB. The default setting is 0 dB. Lower the LFE level if
necessary.
1 2
Repeat step and to change other settings.
When all the configurations have been finished, leave the unit
idle for 5 seconds to exit the Channel Select mode.
ENGLISH