Remote Control Unit 1 - Teac AG-10D Manuel Du Propriétaire

32
All manuals and user guides at all-guides.com
How to use the Remote Control Unit

Remote Control Unit 1

1 Turn on the main power of the component to be operated.
2 Select the component to be operated by pressing the
corresponding REMOTE SELECT button for that component.
When you want to control the TEAC AG-10D receiver, press
the RECEIVER button.
3 Point the remote control unit towards the remote sensor on
the front panel of the component you want to control, and
press the buttons to operate.
Buttons available for each device are listed on page 102.
< Even if the remote control unit is operated within the effective
range, remote control operation may be impossible if there are
any obstacles between the unit and the remote control.
< If the remote control unit is operated near other products
which generate infrared rays, or if other remote control
devices using infrared rays are used near the unit, it may
operate incorrectly. Conversely, the other products may
operate incorrectly.
ENGLISH