Teac AG-10D Manuel Du Propriétaire page 38

1
2
3
38
All manuals and user guides at all-guides.com
Macro Function
Example:
To delete a macro program:
Using a Macro
Remote Control Unit 4
This function enables you to program up to 10 sequential
operations into a single button.
You can store up to three sequences(macros) into the M1, M2
and M3 buttons.
1 Press and hold down both the ENTER button and one of three
numeric buttons (1, 2 or 3) corresponding to the number of
MACRO button (M1, M2 or M3) for more than 1 second.
For example, if you want to program a macro into the M1
button, press the ENTER button and "1".
The LED will flicker once.
2 Press the operation buttons you want to program in order.
Note:
You should press the corresponding REMOTE SELECT buttons
before pressing each operation button.
You want to play a DVD on the DVD player connected to VIDEO
2 jacks of this receiver. You can set a macro to turn on all the
components (Receiver, DVD player and TV) and start playing
the movie all in one press of a button. Once you have put your
remote into the learning mode as shown in the step above,
enter the following:
1. Press the RECEIVER button to control the receiver.
2. Press the POWER button to turn the receiver on.
3. Press the RECEIVER button.
4. Press the VIDEO 2 button to select the input source.
5. Press the TV button to control the TV.
6. Press the POWER button to turn the TV on.
7. Press the DVD button to control the DVD player.
8. Press the POWER button to turn the DVD player on.
9. Press the DVD button.
10. Press the PLAY button to start playback.
3 Press the ENTER button to store the macro.
If the macro is programmed successfully, the LED will flicker
twice.
< If you program a new macro into a MACRO button, the
previously programmed macro will be overwritten.
1 3
Perform steps and , but ignore step
Point the remote control unit towards the remote sensors of
the components to be controlled, and press the MACRO button
(M1, M2 or M3).
< The codes programmed into a MACRO button will be
transmitted at an interval of 0.5 seconds. However, some
components may not be able to complete one operation in 0.5
seconds and may miss the next code. In this case, the macro
function cannot control the corresponding components
correctly.
< Be sure to use the remote control unit within the effective
range of all the components.
< This function may not work correctly on some components.
ENGLISH
2
.