Troubleshooting 1 - Teac AG-10D Manuel Du Propriétaire

88
All manuals and user guides at all-guides.com
If you experience any problems with the unit, please take a
moment to look through this chart and see if you can solve the
problem yourself before you call your dealer or a TEAC service
center.
No power
There is no sound or only a very low-level sound is heard.
No sound from surround or center speakers.
Sound cuts off during listening to the music or no sound even
though power is ON.
Low bass response.
Severe hum or noise is heard.
"DIGITAL" indicator blinks.
No picture.
Cannot view the on-screen display as it rolls rapidly.

Troubleshooting 1

e Check the connection to the AC power supply. Check and
make sure the AC source is not a switched outlet and that, if
it is, the switch is turned on. Make sure there is power to the
AC outlet by plugging another item such as a lamp or fan.
e Adjust the volume by turning the MASTER VOLUME knob.
e If the SPEAKER indicator isn't lit, press the SPEAKER button
to turn it on.
e Check that the speakers and components are connected
securely.
e Check the operation of the connected component.
e Check the audio output setting of your DVD player.
e Select the proper source using the FUNCTION knob and the
DIGITAL INPUTS button.
e Select the proper surround mode (see page 58).
e If "MUTE" is blinking on the display, press the MUTING
button to restore the sound.
e Check the speaker setting (see page 42).
e Check the channel level setting (see page 46~48).
e Select the proper surround mode (see page 58).
e Check the audio output setting of your DVD player. Play a
multi-channel source.
e Speaker impedance is less than prescribed for this unit.
e Turn the power off and reduce the volume.
e Speaker polarity (+/-) is reversed. Check all speakers for
correct polarity.
e Check that the speakers are connected securely.
e Make sure the line cords and speaker cables are as far
away from the AC supply as possible.
e The unit cannot perceive the digital signal (see page 50).
e Select the proper decoding mode by pressing the AUTO
button (see page 58).
e Check that the system is connected properly.
e Turn on the TV.
e Make sure you have selected the proper video input on the
TV so that you can view the pictures.
e Select the proper video source using the FUNCTION knob.
e The color system of the receiver does not match your TV.
Connect a PAL TV.
ENGLISH