Bosch Rexroth SD301 Mode D'emploi page 43

3 609 929 826/06.03 | SD301
5 Menus when connecting the SD301 to a SE31x/SEH312
5.4.1 Power On Menu
Here you can set the current view as the start
menu. The following security question will ap-
pear (Fig. 31).
Fig. 31:
Touching OK saves the current view as the
start screen. Cancel closes this menu.
Not every view may be used as the start
screen. If you select one that cannot be used,
the following error message will appear
(Fig. 32).
Fig. 32:
The Power on menu can be called up from
every level by touching the
menu is not available, i.e. because the
SD301 has been connected to another com-
ponent, the component's Power on menu will
appear.
If the controller has been reset, the last active
menu will be displayed.
5.4.2
This command is used to display counter
records and default values (maximum values)
for OK and NOK counters (Fig. 33). The OK/
NOK counter can be configured in depth in
BS300 at System → OK/NOK counter
configuration.
Fig. 33:
A counter record can be allocated to a corre-
sponding tightening program or using a PLC
table. A total of 48 counter records are avail-
able.
The counter record can be selected using the
appropriate button to open the key pad (see
Chapter 4). If the counter configuration is se-
lected (see BS300 System → OK/NOK
counter configuration) using the program
selection (Prg0-Prg5), the program name is
displayed next to the button (Fig. 33).
Default values for OK/NOK counters can
only be changed when you are logged on
(see section 4.4 on logging on). Use the but-
ton which opens the key pad to change the
respective default value. The counter's value
range is 0..999.
Pressing the Reset counter button resets
button. If the
both counter values.
Bosch Rexroth AG 43/144
OK/NOK counter