Bosch Rexroth SD301 Mode D'emploi page 35

3 609 929 826/06.03 | SD301
5 Menus when connecting the SD301 to a SE31x/SEH312
5.1.2 Actual Values 1
The step results of a tightening job can be
called up in this menu option. You can switch
between result step, docu steps and All
steps.
If the SD301 is operated on a KE31x and you
access a SE31x/SEH312, then the selection
is limited to result step and docu steps
(Fig. 9).
Fig. 9:
The individual steps are displayed in chrono-
logical order. You can scroll up or down
through the lines with the arrow buttons on
the right side of the screen. The scroll posi-
tion will stay the same when the same pro-
gram is started again, the upper position is
displayed when a new program is started
Bosch Rexroth AG 35/144
5.1.3 Actual Values 2
The switch-off criterion and the correspond-
ing value are displayed in the upper section
(here: target function torque 34.20 Nm).
The middle section shows the angle from the
last result step (here: 13.25°).
The following can be scrolled through in the
lower section:
– The total time of the tightening job (tG)
(here: 0.9 s)
– The counter readings
counter (if an OK/NOK counter has been
configured)
– The last entry in the error list (if a system
error has occurred).
If the angle or torque is too large or small
(NOK), an arrow will point up or down ("∆" or
"∇") next to the measured value, which will
flash on the display.
Fig. 10:
1) Displayed inversely when counting
up reaches the default value or coun-
ting down reaches zero
1)
of the OK/NOK