Bosch Rexroth SD301 Mode D'emploi page 39

3 609 929 826/06.03 | SD301
5 Menus when connecting the SD301 to a SE31x/SEH312
If the step is abandoned before this occurs,
the changed value is not transferred to the
program.
If no parameters can be changed within a
tightening step, a corresponding error mes-
sage appears:
Fig. 22:
The parameters for the jump step, conditional
input branch and NOK branch steps cannot
be changed using the SD301.
Sending the program to the controller
Note: Sending the program is only pos-
sible if a user is logged on (see
chapter 4.4)!
First press the +- button and then send to
send the current program:
Fig. 23:
Bosch Rexroth AG 39/144
If the program or menu is abandoned without
the changed program having been sent, the
following message appears:
Fig. 24:
Send sends the current program. Discard re-
sets the changes and Cancel returns the
user to the parameter dialog.