Hartke KM200 Manuel Du Propriétaire page 8

Guided Tour - KM200 Front Panel
9. Line Out – This control knob is used to control the output level the KM200's
mixer section that is being sent to the XLR and 1/4-inch LINE OUTPUT connec-
tors.
10. Volume - Control knob used to control the overall level the KM200 ampli-
fier.
11. Power switch - Use this to power the KM200 on or off.
12. Local/Mix - This slide switch is used to turn off the channel 4 input signal
in the internal amplifier.
13. Line ON/OFF - Slide switch used to turn the LINE OUTPUT SIGNAL on or
off.
14. Volume ON/OFF – This slide switch is used to turn the signal being sent
to the KM200's power amplifier and speaker on or off.
4