Fein Slugger JME Holemaker III Mode D'emploi page 12

OBJ_BUCH-0000000281-002.book Page 12 Tuesday, April 24, 2018 9:09 AM
en
12
Assembly instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
Mounting the spoke handle
(figure 2).
The hub assembly can be mounted on either
side.
Loosen the screw using a hex key.
Remove the spoke handle.
Mount the spoke handle on the other side
and tighten the screw using a hex key.
Fig. 2
1.
3.
2.
4.