Sony Walkman MZ-R70 Mode D'emploi page 8

Notes
• "Data Save" or "TOC Edit" flashes while data of the recording (the track's
start and end points, etc.) is being recorded. Do not move or jog the recorder
or disconnect the power source while the indication is flashing in the display.
• The lid does not open until "TOC Edit" disappears in the display.
To
Record from the end of the
previous recording
Record partway through the
previous recording
Pause
Remove the MD
1) A track mark is added at the point where you press X again to resume
recording while pausing; thus the remainder of the track will be counted as a
new track.
2)
Once you open the lid, the point to start recording will change to the
beginning of the first track. Check the point to start recording on the display.
If the recording does not start
• Make sure the recorder is not locked (page 35).
• Make sure the MD is not record-protected (page 56).
• Premastered MDs cannot be recorded over.
For models supplied with the AC plug adaptor
If the AC power adaptor does not fit the wall outlet, use the AC plug adaptor.
Notes
• If the power supply is disrupted (i.e. the battery is removed or becomes
exhausted or the AC power adaptor is disconnected) during a recording or
editing operation, or while "TOC Edit" appears in the display, then it will not
be possible to open the lid until power is restored.
• You can make a digital recording only from an optical type output.
• When recording from a portable CD player, play it on AC power and disable
the anti-skip function (such as ESP*).
8
-GB
Press
END SEARCH and slide REC.
N, > or . to find the start
point of recording and press x to
stop. Then slide REC.
1)
X
Press X again to resume recording.
x and open the lid.
not open while "TOC Edit"
flashing in the display.)
2)
(The lid does