Relabeling Recordings - Sony Walkman MZ-R70 Mode D'emploi

Labeling a track or a disc during recording
1
While recording, press EDIT for 2 seconds or more so that
"EDIT" flashes in the display, and then press ENTER (x).
" : Name" flashes in the display.
2
To label a track, press ENTER (x) again.
To label a disc, press . or >N repeatedly until
" : Name" flashes in the display, then press ENTER (x).
The track or disc is ready to be labeled.
3
Follow steps 4 to 6 of "Labeling a disc during stop" (page 48).
To cancel labeling, press EDIT for 2 seconds or more or press
T MARK.
Note
When the recording is stopped while labeling a track or a disc during
recording, or when the recording moves on to the next track while labeling a
track, the input at that point is entered automatically.
Available characters
• Capital and small letters of the English alphabet
• Numbers 0 to 9
• !
" # $ % & ( ) * . ; < = > ?
@ _ ` + – ' , / : _ (space)

Relabeling recordings

Follow the steps corresponding to the labeling method until the disc
or track is ready to be labeled. Enter a new character over the one you
want to change, then press ENTER (x for 2 seconds or more on the
remote control).
Notes
• You cannot relabel premastered MDs or label MDs that have not been
recorded.
• The recorder is able to display, but cannot label using Japanese "Katakana"
characters.
• The recorder cannot rewrite a disc or track name of more than 200 letters that
was created by another device.
50
-GB