Sony Walkman MZ-R70 Mode D'emploi page 22

5
While observing the level meter in the display, adjust the
recording level by pressing >MENU., > (+) or .
(–).
Set the level so that the level meter reaches around
mark above the display window.
If the sound is too high, lower the recording level until the level
meter just barely reaches the
window.
Recording doesn't start in this step.
If your source is an externally connected component, be sure to
cue the source to the beginning of the material to be recorded
before you start playback.
6
Press X again to start recording.
To stop recording, press x.
The recording level control is switched back to automatic control when you
record the next time.
Notes
• The recording level cannot be adjusted while recording is in progress. If you
want to adjust the recording level after you have started the recording, press
X to pause the recorder. Then do the procedure from step 5.
• You cannot adjust the recording level manually during synchro-recording.
22
-GB
OVER
–12 dB
REC
Volume decreases
(OVER) mark above the display
+
< ,
increases
(–12 dB)