Setting The Temperature - Dometic B29G Instructions De Montage Et De Service

Using the wine refrigerator
7.8 Switching to Sabbath mode
In Sabbath mode, the display, interior lighting and warning signal for the temperature monitor are deactivated. When the Sab-
bath mode is activated, it switches off automatically after 96 hours. The refrigeration continues as usual.
► Press both the on/off button
The temperature indicator flashes 4 times.
9
The Sabbath mode is activated respectively deactivated.
9

7.9 Setting the temperature

The temperature of each temperature zone can be set between 5 °C and 20 °C (41 °F and 68 °F).
To avoid food waste, note the following:
• Adjust the temperature to the quantity and type of the foodstuff.
• Store the different foodstuff types as shown in the figures.
NOTE:
• If the temperature zones are one above the other, the temperature for the lower zone must always be just as high
or higher than the temperature for the upper zone.
• The wine refrigerator functions at its best if the difference in temperature between the two zones is at least 4 °C
(39 °F).
1. Display the set temperature by briefly pressing the up button
2. If your wine refrigerator has two temperature zones, set the temperature for each zone separately by using the correspond-
ing up button and down button
to decrease the temperature.
The display flashes while you make the setting.
9
Once you have set the temperature, the display shows the current inner temperature again.
9
7.9.1 Setting the temperature unit (°C or °F)
You can select whether the temperature is displayed in Celsius or Fahrenheit.
► Press the light button
The display shows the temperature in the other unit.
9
7.9.2 Displaying the set temperature
NOTE:
When using the wine refrigerator for the first time or if it has not been used for a long time, the inner temperature
could differ from the one you have set. The temperature display flashes as long as this is the case. Once the set
temperature has been reached, the temperature display lights up constantly.
► Press the up button
The display shows the set temperature.
9
After 5 seconds the display shows the current inner temperature again.
9
7.9.3 Switching the fan on/off (dynamic cooling mode or silent mode)
The fan can be operate in two different modes:
• Silent mode: The fan runs only when required. The fan switches off when the set temperature is reached.
• Dynamic cooling mode: The fan runs permanently to regulate humidity and temperature. This way an homogeneous cli-
mate for the interior of a temperature zone is reached.
Silent mode
► Press the up button
Three acoustic signals are emitted.
9
The fan is switched to silent mode.
9
Dynamic cooling mode
► Press the down button
Five acoustic signals are emitted.
9
The fan is switched to dynamic cooling mode.
9
20
and the light button
. Briefly press the up button
for at least 5 seconds.
or the down button briefly.
for at least 5 seconds.
for at least 5 seconds.
for at least 5 seconds.
or the down button
to increase the temperature or the down button
4445103123
Wine Refrigerators
(fig. and , on page 12).
EN