Cleaning And Maintenance - Dometic B29G Instructions De Montage Et De Service

Wine Refrigerators
7.9.4 Monitoring the temperature
The warning signal prevents the temperature from falling or rising too much unnoticed, which could affect the quality of the
wine. Once the unit has reached the set temperature, the warning signal and the temperature display flashing stops.
A warning signal sounds and the temperature display flashes in the following cases:
• The inner temperature of a zone deviates from the set temperature by more than 5 °C.
• The power supply has been disconnected for a long time.
• The door has not been shut properly.
• The door is open for more than 60 seconds.
To switch off the warning signal prematurely:
► Press the on/off button
The temperature display flashes until the set temperature is reached. The display is then illuminated constantly and indi-
9
cates that the alarm system is active again.
8

Cleaning and maintenance

WARNING!
• Disconnect the wine refrigerator from the mains before cleaning and maintenance.
• If the wine refrigerator connection cable is damaged, it must be replaced by the manufacturer, customer service
or a similarly qualified person in order to prevent safety hazards.
• The wine refrigerator may only be repaired by qualified personnel. Inadequate repairs may cause serious haz-
ards. In need of repairs, contact customer services.
NOTICE!
• Never pull the plug out of the socket by the connection cable.
• Clean the wine refrigerator and disconnect it from the mains if it is empty and you will not need to use it for some
time. Leave the door of the disconnected wine refrigerator open to avoid mould.
8.1 Cleaning
NOTICE!
• Never clean the wine refrigerator under running water or in dishwater.
• Do not use abrasive cleaning agents or hard objects during cleaning as these can damage the wine refrigerator.
• Make sure that the air inlet and outlet vents on the unit are free of any dirt, so that heat from the interior can be
released and the unit is not damaged.
Regularly clean the wine refrigerator (fig.
1. Empty the wine refrigerator.
2. Switch off the wine refrigerator and disconnect the plug.
3. Remove the shelves for optimum cleaning (fig.
4. Wash the inside with a solution of warm water and baking powder. This should be about two tablespoons of baking pow-
der to half a liter of water.
5. Only wipe the control panel with a slightly damp cloth.
6. Wash the outside of the wine refrigerator with warm water and a mild detergent.
7. Wipe it down with clean water and dry the surface with a cloth.
8. Clean the shelves with mild detergent.
9. Insert the shelves.
8.2 Checking the water level (humidity control)
If your wine refrigerator is equipped with a water tank, regularly check the water level and change the water (fig.
6).
1. Take out the water tank.
2. Empty the water tank and clean it.
3. Fill the water tank 2/3 full with water and place it on the grid on the top shelf.
4. Make sure that the water tank is securely positioned on the grid so that it cannot tip over.
EN
briefly.
, on page 6).
, on page 6).
4445103123
Cleaning and maintenance
, on page
21