What To Do If - AEG 68001K-MN Instructions De Montage Et Mode D'emploi

What to do if ...

Problem
The cooking zones will not
switch on or are not func-
tioning
The residual heat indicator
is not displaying anything
The automatic warm up
function is not switching
itself on
Repeated acoustic signal
(6x), appliance switches off
Acoustic signal sounds and
appliance switches itself on
and then off again; after 5
seconds another acoustic
signal sounds
Display is switching be-
tween two heat settings
20
All manuals and user guides at all-guides.com
Possible cause
More than 10 seconds have
passed since the appliance
was switched on
The lock is switched on
The child safety device is
switched on
Several sensor fields were
touched at the same time
The sensor fields are partly
covered by a damp cloth or
with liquid
Safety cut-out has been
triggered
STOP+GO is activated
The cooking zone was only
on for a short time and is
therefore not hot
There is still residual heat
on the cooking zone h
The highest heat setting is
set Ç
One or more sensor fields
have been covered for
longer than 10 seconds
The On/Off sensor field has
been covered up, e.g. by a
cloth
Power management is re-
ducing the power of this
cooking zone
Switch the appliance on
again.
l
Switch off the lock (See
the section "Locking/un-
locking the control panel")
Deactivate the child safety
l
device (See the section
"Child safety device")
Only touch one sensor field
Remove the cloth or the
liquid.
Switch the appliance on
again.
Switch the appliance on
again
Switching off STOP+GO
If the cooking zone is sup-
posed to be hot, call the
Customer Service Depart-
ment.
Let the cooking zone cool
down
The highest heat setting
has the same power as the
automatic warm up func-
tion
Uncover sensor field
Do not place any objects
on the control panel
See the section "Switching
the power function on and
off"
Remedy