Changing The Throttle Limit - Horizon Hobby Axial Yeti Jr Can-Am Maverick X3 X RS TURBO R Mode D'emploi

BINDING
Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifi er) code of a single specifi c transmitter.
1. Power OFF the ESC/Receiver and transmitter.
2. Connect a fully charged battery to the ESC/Receiver.
3. Power on the ESC/Receiver. It will beep once and the LED will fl ash rapidly, indicating it is in bind mode.
4. To put the STX2 transmitter into bind mode, hold the steering wheel fully to the right while powering on the transmitter. Release the steering wheel
after 2 seconds.
5. The LED on the ESC/Receiver will go solid and the ESC/Receiver will make a rising tone, indicating the bind is successful. You must rebind when
binding the receiver to a different transmitter.
NOTICE: Do not attempt to bind the transmitter and receiver if there are other compatible transmitters in bind mode within 400 feet. Doing so may
result in unexpected binding.
WATER-RESISTANT COMPONENT
Your new Horizon Hobby SRX210 receiver has a special water-resistant coating on the electronics to ensure reliable performance in higher than average
moisture conditions. This conformal coating can offer mild protection from light drops of water.
• DO NOT submerge this product under water for any period of time. If it is submerged, it may result in damage or loss of function.
• DO NOT pour water onto or allow excess water to come in direct contact with the product.
• DO NOT operate this product inn heavy rain or snow.
• DO NOT expose this product to salt water (ocean water or water on salt-covered roads), contaminated or polluted water.
In case of excess exposure to water or debris, immediately wipe down the SRX210 with a soft cloth and allow it to fully dry before next use.
NOTICE: Never use a pressure washer to clean your vehicle.
NOTICE: Make sure the other components in your vehicle are waterproof or water-resistant before driving in wet conditions.

CHANGING THE THROTTLE LIMIT

BEGINNER MODE
Throttle Limiting Switch: 50%
• Best for learning the basic functions of left, right, stop, brake and reverse.
• For use in smaller areas
• Longest battery life
BEST OVERALL PERFORMANCE (DEFAULT)
Throttle Limiting Switch: 75%
• Great top speed and acceleration
• Easier to accelerate in desired direction, especially on loose surfaces
when compared to maximum speed setting
• Run time is greatly increased over maximum speed setting with minimal
impact on top speed
MAXIMUM SPEED
Throttle Limiting Switch: 100%
• More capable of popping and holding wheelies
• Higher top speeds and maximum acceleration
Throttle Limit Switch