Ice And Water - Whirlpool WRF767SDHV Guide D'utilisation Et D'entretien

PROBLEM
There is interior
moisture buildup
NOTE: Some moisture
buildup is normal.
There is frost/ice
buildup in the freezer
compartment

Ice and Water

PROBLEM
The ice maker is not
producing ice or is not
producing enough ice.
The ice cubes are
hollow or small.
NOTE: This is an
indication of low water
pressure.
POSSIBLE CAUSES
The room is humid.
The door(s) are opened often or not
closed completely.
The door is blocked open.
A bin or shelf is in the way.
Storing liquid in open containers
The drawer is opened often or left
open.
Poor door seal
Temperature controls are not set
correctly.
POSSIBLE CAUSES
The refrigerator is not connected to
a water supply or the water supply
shut-off valve is not turned on.
There is a kink in the water source
line.
The ice maker is not turned on.
The refrigerator has just been
installed.
The refrigerator door is not closed
completely.
A large amount of ice was recently
removed.
An ice cube is jammed in the ice
maker.
A water filter is installed on the
refrigerator.
A reverse osmosis water filtration
system is connected to the cold
water supply.
The water shut-off valve is not fully
open.
There is a kink in the water source
line.
A water filter is installed on the
refrigerator.
A reverse osmosis water filtration
system is connected to the cold
water supply.
Questions remain regarding water
pressure.
TROUBLESHOOTING
SOLUTIONS
A humid environment contributes to moisture buildup.
Allows humid air to enter the refrigerator. Minimize
door openings
and close doors completely.
Move food packages away from door.
Push bin or shelf back into the correct position.
This adds humidity to the refrigerator interior. Keep all
containers tightly covered.
Minimize drawer openings and close drawer
completely after use.
Ensure door seals are making full contact with the
refrigerator cabinet to allow for an adequate seal.
See "Using the Control(s)" for recommended
temperature settings.
SOLUTIONS
Connect refrigerator to water supply and turn water shut-off
valve to fully open.
A kink in the line can reduce water flow. Straighten the water
source line.
Make sure the ice maker is on. See the "Ice Maker and Storage
Bin" section.
Wait 24 hours after ice maker installation for ice production to
begin. Wait 3 days for full ice production.
Close the door firmly. If it does not close completely, see "The
doors will not close completely" in this table.
Allow sufficient time for ice maker to produce more ice. See the
"Ice Maker and Storage Bin" section for ice production rates.
Remove ice from the ice maker with a plastic utensil.
Remove the water filter and operate the ice maker. If ice volume
improves, then the filter may be clogged or incorrectly installed.
Replace filter or reinstall it correctly.
This can decrease water pressure. See the "Water Supply
Requirements" section.
Turn the water shut-off valve fully open.
A kink in the line can reduce water flow. Straighten the water
source line.
Remove filter and operate ice maker. If ice quality improves, then
the filter may be clogged or incorrectly installed. Replace filter or
reinstall it correctly.
This can decrease water pressure. See the "Water Supply
Requirements" section.
Call a licensed, qualified plumber.
35