Ingenico P30 Notice D'installation page 2

page de 2

/ 2
Signets

Les langues disponibles

P30 / P30 contactless installation manual

Safety instructions : Lithium battery :

P30 / P30 contactless equipment is equipped with a lithium battery that is non-accessible for the user. Only a qualified operator is

authorized to open the unit and to replace this component.

Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.

Keypad

Flèche haut

Flèche bas

Function

Cancel

Clear

Validate

Physical characteristics:

Operating conditions:

Storage conditions:

Maximum consumption:

Montage et démontage du câble

Press the locking device

Hang on the connector

ICES-003 Compliance

P30

—

FCC ID : XKB-P30 – XKB-P30CL

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interface in a residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with instruction, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television

reception which can be determined by turning the equipment off and on, the user is encouraged to try to correct interface by one or more of the

following measures :

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into a outlet on circuit different from that to which the receiver is connected.

•

Consult the dealer or an experience radio/TV technician for help.

CAUTION

: The user is cautioned that any changes or modification not approved by INGENICO could void user's authority to operate the equipment

Security of your terminal

Upon receipt of your terminal you should check for signs of tampering of the equipment. It is strongly advised that these checks are performed

regularly after receipt. You should check, for example: that the keypad is firmly in place; that there is no evidence of unusual wires that have been

connected to any ports on your terminal or associated equipment, the chip card reader, or any other part of your terminal. Such checks would provide

warning of any unauthorised modifications to your terminal, and other suspicious behaviour of individuals that have access to your terminal. Your

terminal detects any "tampered state". In this state the terminal will repeatedly flash the message" Alert Irruption!" and further use of the terminal will

not be possible. If you observe the "Alert Irruption!" message, you should contact the terminal helpdesk immediately. You are strongly advised to

ensure that privileged access to your terminal is only granted to staff that have been independently verified as being trustworthy.

End-of-life

The product belongs to the family of electrical and electronic equipment. Therefore, it is subjected to the WEEE directive which requires the collection

and the recycling at the end of life product. The Ingenico products present the symbol for the marking of electrical and electronic

equipment as required by the WEEE Directive. The crossed-out wheeled bin printed on the product gives the information about the

requirement not to dispose of WEEE as unsorted municipal waste and to collect such WEEE separately. To assure that the product is

collected and recycled with respect to the environment, you must contact your supplier (in defect, contact the Ingenico local office or the

commercial head office in charge of your country on www.ingenico.com, « contact us » page). The abandonment or uncontrolled disposal

of waste can cause harm to environment and to human health. So, by recycling your product in a responsible manner, you contribute to the

preservation of natural resources and to the protection of human health.

295007020

INGENICO – 192 avenue Charles de Gaulle – 92200 Neuilly sur Seine - FRANCE

Tél. 33(0)1 46 25 82 00 - Fax 33 (0)1 47 72 56 95

www.ingenico.com

Inserting and sliding the