Electrical Box; Electrical Panel Assembly - Vitrifrigo MACS 7 Serie Manuel D'installation

9. ELECTRICAL BOX

Any electrical installation must be carried out by professionally qualified personnel in compliance with
current regulations.
Before performing any installation on the electrical component, disconnect the power
supply from the air conditioner on the boat's electrical panel, to avoid the risks due to high
voltage.
If the wiring diagram supplied with the air conditioner differs from that contained in this manual, refer to the
diagram that accompanies the machine. The electrical wiring diagram is on rear part of sheet metal cover of
the electrical box.
9.1

Electrical panel assembly

The MACS electrical panel is supplied connected to the machine. Check it before switch on the machine that
all components are plug in according to fig. 9. The installer will only have to make the electrical connection
of the hydraulic pump, the control panel and the general power supply of the electrical panel. For a correct
plug in, follow the diagram of the electrical panel and the indications in the following paragraphs.
The electrical box of the machine is free-standing with a maximum distance of 1 m, follow the installation
instructions below.
Mount the controller in a dry location and on a flat surface.
Fixing the line ground wire in the specific pin (5 in fig. 8).
To instal the electrical box using the four holes (pos. 4 in fug. 8) using screws suitable for the support material.
1 Electrical board
2 Compressor condenser
5 Ground terminals
Fig. 8 (MACS electrical panel)
3 Fan condenser
4 Holes for installation
73