Connection And Display Components; Installation Instructions - Festo CPX-FVDA-P Mode D'emploi

CPX-FVDA-P...
3

Connection and display components

Design of output module
9
8
7
6
Fig. 4: Design of output module CPX-FVDA-P
The use of non-specified connection and interlinking blocks is not permissible.
4

Installation instructions

Warning
S Use only PELV circuits complying with IEC/DIN EN 60204-1 for the electrical
supply (protective extra low voltage, PELV).
Also observe the general requirements for PELV circuits in accordance with
IEC/DIN EN 60204-1.
S Use only power sources that guarantee safe electrical isolation of the operat-
ing voltage in compliance with IEC/DIN EN 60204-1.
Festo CPX-FVDA-P... 1011NH English
Description
– Connection block
CPX-M-4-M12X2-5POL 1
1
– Electronics module
– DIL switch for PROFIsafe address
Mechanical coding 4
–
– Interlinking block with contact rails
CPX-M-GE-EV-FVO 5
2
– Rating plate (on base)
– Electric plug connector
3
8
– Module LEDs
– Screws, tightening torque
9
0.9 ... 1.1 Nm
4
5
CPX-FVDA-P 2
3
6
7
27